Eibenstock EBM 182/3 Originalbetriebsanleitung Seite 19

Application for Indented Purpose
The Diamond Core Drill EBM 182/3 is indented for professional use and may
be used by instructed personnel only.
With the appropriate wet drill bits, the unit may be used for wet drillings only,
e.g. in concrete, stone and masonry.
It may be used completely mounted only.
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction completely and follow the
instructions contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the mains cable gets damaged or cut during use, do not
touch it, but instantly pull the plug out of the socket.
Never use the tool with a damaged mains cable.
When drilling in ceilings or walls make sure you will not
cut through electrical mains, gas or water pipes. Use
metal detection systems if needed.
Before you start working, consult a statics specialist to
determine the exact drilling position.
If drilling through ceilings, secure the place below,
because the may fall downward.
Pay attention that the tool is not exposed to direct rain.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill in asbestos-containing materials.
Never carry the tool at its cable and always check the tool, cable and plug
before use. Have damages only repaired by specialists. Insert the plug into
the socket only when the tool switch is off.
Modifications of the tool are prohibited.
The machine should only work under supervision of sbd. Plug and switch
the machine off if it is not under supervision, e.g. in case of putting up and
stripping down the machine, in case of voltage drop or when fixing or
mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it
starts suddenly and not under supervision.
Do not use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
During work, always lead the mains cable, extension cable and extraction
hose to the back away from the machine.
Power tools have to be inspected visually by a specialist in regular
intervals.
19