Aux Send Module; Group Module - Yamaha MX400 Bedienungsanleitung

10
5
0
1
5
10
15
20
30
40
∞
2
PEAK
0
3
–20
4
ON
5
AFL
1
TO ST
2
L R
PAN
3
ON
4
AFL
10
5
5
0
5
10
15
20
25
30
40
∞

AUX SEND module

1
AUX SEND fader
This adjusts the signal level of the AUX SEND output. A position at the zero
(0) marking is the nominal level. Raising the fader above 0 provides up to
10dB of gain.
2
PEAK indicator
This indicator lights when the level of the input signal reaches 3dB before
clipping.
3
Signal (0/–20) indicator
The 0dB indicator (yellow) lights when the output signal level reaches +4dB.
The –20dB indicator (green) lights when the output signal reaches –16dB.
4
ON switch
This switch turns the AUX SEND on/off. When the switch is pressed in it is
turned on. When off, no signal will be output from the corresponding AUX
SEND jack.
5
AFL (After Fader Listen) switch
This monitors the AUX SEND signal. This is on when the switch is pressed
in.

GROUP module

1
TO ST switch
This sends the GROUP signal to the stereo bus.
2
PAN control
This adjusts the panning of the signal sent to the stereo bus.
3
ON switch
This switch turns the GROUP on/off. The group is on when the switch is
pressed in. When off, no signal will be output from the corresponding
GROUP OUT jack.
4
AFL (After Fader Listen) switch
This monitors the GROUP signal. This is on when the switch is pressed in.
5
Group fader
This fader adjusts the signal level of the GROUP output.
AUX SEND module
MX400 User's Guide
7