Linea 2000 DOMO DO8141 Anleitungsheft Seite 30

Loosen the clamp and extend the top part of the tube completely and block the tube at this
height by tightening the clamp again.
Make sure that the clamp is tightened before mounting the motor. Loosen the large screw
at the back of the control panel (a). Place the motor on the telescopic tube. Tighten the large
lly.
screw again, making sure that the screw is aligned with the recess in the telescopic tube. The
replaced by manufacturer
large screw must be fully tightened prior to using the fan.
d person in order to avoid
ock, do not immerse the
ged from 8 years and
sensory or mental
edge if they have been
use of the appliance in
olved. Children shall not
maintenance shall not be
ore cleaning, unplug the
blade guard shall not be
ONS
duct should not be
roughout the EU. To
t or human health from
sponsibly to promote the
FASTENING THE GRILL AND THE FAN BLADES
To return your used
on systems or contact
ased. They can take this
Place the back of the grill on the motor drive. Secure it using the open plastic screw. Place the
fan blades on the motor drive. Make sure the pin on the motor drive fits perfectly behind the
fan blades. Secure the fan blades on the motor drive using the closed plastic screw.
ugh the grille when fan is
nother.
avoid overturning.
al hazard.
30
DO8141
INSTALLATION INSTRUCTIONS
Name of components
Support Installation
Align the Column Pipe
connection plate with
holes on the support and
tighten screws.
1. Align Screw Holes on the outer ring
of both the Front and Rear Guards,
with the Positioning Clip aligned as
illustrated.
Considerate Hint:
Remove ①②parts from the
component before performing
installation.
Blade
Pull the blade to rotate after installing,
so as to ensure that the blade can be
normally rotated.
a
Front and Rear Guard Installation
2. Press down all the Buckles to fasten the
Front Guard with the Rear Guard. At the
Screw Holes, tighten the separated screw
and nut.
2 2
Front and Rear Guard Installation
1. Align Screw Holes on the outer ring
of both the Front and Rear Guards,
with the Positioning Clip aligned as
illustrated.
INSTRUCTIONS FOR USE
Instructions for key of remote
Screw
"SPEED" key
Blade
Pull the blade to rotate after installing,
Buckle
so as to ensure that the blade can be
normally rotated.
Screw the lock nut of grill clockwise,
and in the meantime, fix the rear grill.
Considerate Hint:
Effective Range of Remote Cont
30-degree deflection in front of P
Instructions for display of bod
Speed display
2. Press down all the
Front Guard with the
Screw Holes, tighten
and nut.
3