Product Disposal; Manufacturer Contact - Voith Argo Hytos Rperx3-06 Bedienungsanleitung

The storage conditions for seals are specified in ISO 2230 - Rubber products - Storage guidelines:
Seals to be stored:
› in covered, dry and tempered areas at temperatures of +15 to +25 °C, away from direct heat sources
› protected from the weather, direct sunlight and ultraviolet radiation
› undeformed, on a clean flat base in the original packaging
› out of reach of petroleum and chemical substances
Rubber group Chemical name abbreviation according to ISO
A Polyurethane PU
B NBR
C FKM / FPM (Viton)
C VMQ

7.9 Product disposal

Remove the valve from the hydraulic circuit (see chapter 7.6.1 Replacing a defective valve). Remove as much residual working fluid
from the valve as possible. Dispose of the valve in an environmentally friendly manner in accordance with
the applicable regulations. The valve is mainly made of recyclable materials such as low carbon steel, copper wire, etc.
(see chapter 4.2 Materials used).

8. Manufacturer contact

ARGO-HYTOS s.r.o.
Dělnická 1306 • CZ - 543 01 VRCHLABÍ • Czech Republic
Tel. +420 499 403 111 • E-mail:
Page 20
Chemical composition
Polyester urethane rubber
Butadiene acrylonitrile rubber
Fluoroelastomer
Vinyl methyl - silicone rubber
info.cz@argo-hytos.com
Length of storage
5 years
7 years
10 years
10 years
Operating instructions_RPERX3-06_14095_3en_07/2024
www.argo-hytos.com