Ruris RX355S Handbuch Seite 32

EN
Speed control
The gear lever is located on the handle on the right side. It is used to regulate the engine speed.
Attention : To stop the engine proceed as follows: the engine acceleration is reduced to the minimum,
after which the stop handle is released. Do not stop with the emergency stop handle when the
engine is at maximum speed, except in case of emergency
When the control lever is moved towards the rabbit symbol the engine speed increases.
When the control lever is moved to the frog symbol the engine speed decreases.
CAREFUL!
Operate the lever only when the engine is running. Operating the lever without the engine running can
damage the drive mechanism.
To decrease travel speed, push the lever in the forward direction.
To increase travel speed, pull the lever back.
The travel speed will be suitable according to the working conditions (land and lawn).
CUTTING HEIGHT ADJUSTMENT
NOTE: Your machine is shipped with the cutting height in the low position. Adjust the cutting height as
follows.
The height adjustment lever is located above the right rear wheel. To adjust the cutting height, move the
lever outwards and move it forward or backward one step.
NOTE: For uneven or unstable terrain, move the cutting height to a higher position.
13