Ruris RX355S Handbuch Seite 29

EN
Check the oil level in the engine bay.
Connect the plug to the spark plug
* Note: For models with electric start function. *
Before using the electric start function, the battery must be
charged for 5 hours. Insert the charger plug into the battery
hole and connect the charger to a power source.
The engines equipping these machines can be equipped with:
- Priming pump
- Manual shock
- Thermal shock
STARTING: For engines equipped with a priming pump
Starting by actuation (starter): Prime the carburetor by actuating the priming pump located on the air filter
cover (3-4 actuations). Pull the emergency stop handle with your left hand and stick it to the guide handle.
Grasp the starter handle with your right hand and pull gently until you feel resistance. Then pull steadily to
start the engine. After the engine has started, let it reach maximum speed, after which you can start
working.
STARTING: For engines equipped with thermal shock
Pull the emergency stop handle with your left hand and stick it to the guide
handle. Grasp the starter handle with your right hand and pull gently until you
feel resistance. Pull steadily to start the engine. After the engine has started,
let it reach maximum speed, after which you can start working.
STARTING: For engines equipped with manual shock
Push start (starter): Pull the emergency stop handle with your left hand and
stick it to the guide handle and position the choke lever in the closed position
and operate the throttle lever to full (if equipped). Grasp the starter handle with your right hand and pull
gently until you feel resistance, then steadily to start the engine, then move the choke lever to the open
(operating) position. After the engine has started, let it reach maximum speed, after which you can use it
for work.
AUTOMATIC START (with the key): If the machine is also equipped with automatic start, the start will be
done by operating the key following the starting steps depending on the engine equipment.
8.2. STOPPING
Release the safety brake (engine-stop) control lever.
Note: Shutdown (for machines equipped with an accelerator lever, the stop will be made after reducing
the engine speed to minimum, after which you release the control handle of the engine-stop safety brake).
10