Ruris RX555S Handbuch Seite 53

The machine ○ Engine speed too low
does not cut
the lawn ○ Wet lawn
○ Grass too tall
○ Knife damaged (not sharp)
Uneven cut ○ Wheels not properly positioned
○ Used knife
NOTE: For repairs other than the above adjustments, contact the nearest authorized RURIS
service.
The following steps must be followed to prepare the lawnmower for storage.
⚫
Clean and lubricate the machine carefully as described in the instruction manual.
⚫
Coat the machine knife with petroleum jelly to prevent rusting.
⚫
Store the machine in a dry and clean area. Do not store it near corrosive material
or heating sources (central, stoves).
⚫
Empty the fuel from the tank.
⚫
Start the machine and let it run until the fuel in the carburetor is used up and it stops.
11. STORAGE
○ Adjust carburetor or governor levers
(service).
○ Do not mow the lawn when it is wet,
wait until it dries.
○ Cut once to high height then cut
again to desired height
○ Sharpen or replace the knife
○ Place all wheels in the same position
○ Sharpen or replace the knife
EN
25