Set-Up And Function; Overview E300; Brief Description; Transport, Packaging And Storage - Linde E300 Gebrauchsanweisung

4. SET-UP AND FUNCTIONS

4.1. OVERVIEW E300

Illustrations and images in these instructions serve to ensure a basic understanding of the system and may
differ from the actual version.

4.2. BRIEF DESCRIPTION

Extension Header Rails are used to increase the number of high-pressure inlet ports for gas supply manifolds.
There can be up to four additional inlet ports per side of the gas supply manifold. They are available in brass
chrome plated.

5. TRANSPORT, PACKAGING AND STORAGE

TIPS AND RECOMMENDATIONS!
•
The installation and start- up of this gas supply panel is normally done by the supplier or by authorized
personnel.
•
Even though there can be some users or maintenance personnel who care about the packaging. The fol-
lowing notes should be observed accordingly.

5.1. SAFETY INFORMATION FOR TRANSPORTATION

NOTE!
•
Damages caused by inappropriate transportation!
•
If transported inappropriately, consignments can fall or topple over. This can cause considerable property
damage.
•
When unloading the consignments on delivery and transporting them on the premises, act with caution
and observe the symbols and warnings on the packaging.
•
Use only the attachment points provided.
•
Do not remove the packaging until you are ready to assemble the regulator.

5.2. TRANSPORT INSPECTION

Upon delivery, check immediately that the consignment is complete and has not been damaged during tran-
sit. Procedure on detection of visible transport damage:
•
Refuse acceptance of the delivery or only accept subject to reservation
•
Record the extent of the damage on the transportation documentation or on the forwarder's delivery note
•
File a complaint
13/40
EN