Intended Use; General Notes - EOS 46.U compact Montage- Und Gebrauchsanweisung

Dear Customer,
You have purchased a high quality technical ap-
pliance which will provide you with many years
of enjoyable sauna bathing. This sauna heating
system was constructed in accordance with la-
test European safety standards, inspected and
manufactured in accordance with the Quality
Standard DIN EN ISO 9001:2000.
This detailed installation and user's guide was
created for your information. Please note espe-
cially the important information and the detaila
dealing with the electrical connection.
We wish you a richly invigorating and restora-
tive sauna bathing experience.

Intended use

This sauna heater is exclusively designed for
the heating of sauna cabins, in connection with
an appropriate control unit.
Any use apart from the de ned application
shall be regarded as non-intended use. Adhe-
rence to the conventional operating, mainte-
nance and servicing conditions is also part of
the intended use.
The manufacturer cannot be made responsi-
ble for deviating alterations undertaken on the
authority of the user and any consequential
damage. The risk for such measures shall be
borne solely by the person carrying out the al-
terations and causing the damage.
16

General notes

Please note that an optimal sauna climate can
be reached only when the cabin, with its air in-
take and exhaust, the sauna heating unit and
the control unit have been tuned for compati-
bility with one another.
Please note all data and information provided
by your sauna supplier.
The sauna heating units warm your sauna ca-
bin through means of heated air convection.
To this end, fresh air from the air intake vent is
drawn in, rises upon warming (convection) and
is then circulated through the cabin. A part of
the used air is pushed out through the exhaust
vent in the cabin. This is the means by which
the typical sauna climate develops, reaching
characteristic temperatures of about 110° C
directly under the ceiling of your sauna, which
fall o to about 30-40°C in the oor area due
to the temperature gradient in the sauna cabin.
Therefore, it is not unusual when, for example,
temperatures of 110°C prevail in the area of
the temperature sensor over the oven, while
the thermometer, which is installed 20-25 cm
under the cabin ceiling on the sauna wall, regi-
sters only 85° C. With a temperature setting at
maximum, the mean bathing temperature lies
between 80°C and 90°C in the area of the upper
recliner bench.
Please note that the highest temperature va-
lues in the cabin always develop in the area
above the sauna heating unit and that the tem-
perature sensor and safety limiter must be in-
stalled in this area in accordance with the con-
trol unit installation guide.
At the initial heating, you may notice a slight
odor arising from evaporation of substances
from the manufacturing process. Air out your
cabin after this cycle before you begin with the
sauna bath
First of all check whether the sauna heater
has arrived at your site undamaged. Regi-
ster transport damage claims immediately
with the delivering transport company or
please contact the supplier who provided
the equipment to you.
GB