Specifications - Hitachi DB 3DL Bedienungsanleitung

PRECAUTIONS FOR CORDLESS DRIVER
DRILL
1. Alw ays charge the battery at a tem perature of 10 –
40° C. A tem perature of less than 10° C w ill result in
over charging w hich is dangerous. The battery
cannot be charged at a tem perature higher than
40° C.
The m ost suitable tem perature for charging is that
of 20 – 25° C.
2. When one charging is com pleted, leave the charger
for about 15 m inutes before the next charging of
battery.
Do n o t ch ar g e m o r e t h an t w o b at t er i es
consecutively.
3. Do not allow foreign m atter to enter the hole for
connecting the rechargeable battery.
4. Never disassem ble the rechargeable battery and
charger.

SPECIFICATIONS

POWER TOOL
No-load speed (Low /High)
M etal
Drilling
(Thickness 1.0 m m )
Capacity M achine screw
Driving
Wood screw
Rechargeable battery
Weight
CHARGER
M odel
Charging voltage
Weight
STANDARD ACCESSORIES
1 Plus driver bit (No. 2 × 50L) ............................... 1
2 Battery (EBM 315) ...................................................... 1
3 Charger (UC3SFL) ............................................................ 1
4 Plastic case ................................................................ 1
Standard accessories are subject to change w ithout
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (EBM 315)
Optional accessories are subject to change without notice.
UC3SFL
3.6 V
0.3 kg
5. Never short-circuit the rechargeable battery. Short-
circuiting the battery w ill cause a great electric
current and overheat. It results in burn or dam age
to the battery.
6. Do not dispose of the battery in fire.
If the battery is burnt, it m ay explode.
7. When drilling in w all, floor or ceiling, check for
buried electric pow er cord, etc.
8. Bring the battery to the shop from w hich it w as
purchased as soon as the post-charging battery life
becom es too short for practical use. Do not dispose
of the exhausted battery.
9. Using an exhausted battery will damage the charger.
10. Do not insert object into the air ventilation slots of
the charger.
Inserting m etal objects or inflam m ables into the
charger air ventilation slots w ill result in electrical
shock hazard or dam aged charger.
200 / 600 m in
Steel: 2 m m ,
Alum inum : 2 m m
5 m m
3.5 m m (diam eter) × 20 m m (length)
(Requires a pilot hole)
EBM 315: Li-ion 3.6 V (1.5 Ah 1 cell)
0.4 kg
APPLICATIONS
Driving and rem oving of m achine screw s, w ood
screw s, tapping screw s, etc.
Drilling of various m etals
BATTERY REM OVAL/ INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery release
buttons (2 pcs.) to rem ove the battery (see Figs. 1 and
2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery w hile observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follow s.
1. Connect the charger's pow er cord to a receptacle.
2. Insert the battery into the charger.
Firm ly insert the battery into the charger till it contacts
the bottom of the charger and checking the polarities
as show n in Fig. 3.
English
–1
6