Onkyo R-100 Bedienungsanleitung Seite 13

How to Check the Timer Reservation
Follow the procedures below for checking the time which is set
by the timer reservation.
Example:
Checkingthe timer setting by which the unit startsat 20:00and
stops at 20:30.
1
Recording on the Tape Deck from the Program Source
I Selectthe desired recordingsourcewith the SOURCEbutton.
2 Begin tape deck recording operations.
3 Begin programsource performance.
NOTE:
Be careful not to change the SOURCEbutton while recording.
Video Disc Player to Video Cassette Recorder Dubbing
Video disc programs can be recorded onto VCR.
I Load a disc in the video disc player, and a blank tape in VCR.
2 Selectthe VDPby using the SOURCE button
@ Begi n playbac k ofthe video d isc player and recording
VCR.
@ VDP to VCR duplication i spossible when VDP output i scon-
nected to the VDP jacks.
O Refer t o thevideodiscplayer a ndVCR instruction m anuals for
additional information.
Use the PROCESSOR jacks for simultaneous
of recording done With a 3-head type tape deck.
(See illustration for connections.)
R-IOO
1 Select the source with the SOURCEbutton.
2 Begintape deck recording operation.
3 Beginprogram sourceperformance.
4 Simultaneo us monitoring ofarecording ispossible bysetting
the tape monitor switch onthe tape deckto the TAPEposition.
• Be careful not to change the SOURCE button while re-
cording.
• Simultaneous monitoring of a recording is not possible with
a 2-head tape deck or a DAT, but connection is possible.
2
2
ofthe
O Select t he desired listeningsource with the SOURCE button.
@ Beginperformance.
monitoring
REC PLAY
TAPE DECK
- 12 -
Press the POWER ON.
Press PROGRAM two times in quick succession.
• "CHECK" will come on, and then the time (20:00)
will come ON is displayed. "ON" will flash for 5 seconds.
Artistry in Sound
The "OFF" time (20:30) is displayed and the OFFindicator
flashes at the same time for 5 seconds.
Artistry in Sound.
1_11 r *
snND-e•r• AUTO
Using a Mixing Console or Graphic
Connect this unit's PROCESSOR
equalizeds INPUTjack, and this unit's PROCESSOR IN jack with
the graphic equalizer's OUTPUT jack.
R-IOO
tf no processoror graphic equalizer is connected, use the jumper
plug provided to short the these terminals.
Equalizing Audio Source Performance
NOTE:
Under DIRECT conditions, the equipment connected to the
processor jackswill becomeuseless, s o alwaysbe sureDIRECT
has been canceled.
when this
111 l¯l.nn
r_ J—l.uu
4
717. -l
L
Equalizer
OUT jack with the graphic
INPUT OUTPUT
GRAPHIC EQUALIZER