Sharp RP-103H Bedienungsanleitung Seite 6

AC VOLTAGE
POINTS TO
Do not use force when
POWER SWITCH
Turn the switch ON when
press the switch to piace the unit in d) STAND-BY.
• Unplug the AC supply lead when not being used for
prolonged periods of time.
At time the turntable platter
the PLAY [CUT button is pressed immediately
turning the POWER switch ON.
the micro-computer which
until it is ready to operate.
try again.
*OUTPUT CABLES
These cables are especially
stereo receiver SA-103H
SA-103H should not be connected.
SELECTOR
REMEMBER
pressing or pulling the door.
using. When finished using,
may not operate when
after
This is because Of
needs a short . interval
Wait a few seconds and
designed for use with
and therefore units other
Check the setting of the AC voltage selector located on the rear
panel before plugging
adjust the selector to correspond
in your area.
Selector adjustment:
Turn the selector with
number appears in the window.
FOR
When opening or closing
gently.
PLAY/CUT
When the turntable
this button will close it and the record will begin playing.
RECORD
*SIDE A/B
When the POWER
cator (green) will always light up.
the
than
2
the unit into an AC outlet.
to the AC power voltage used
a screwdriver until the appropriate
(1 IOV, 220V or 240V)
OPERATION
the turntable compartment,
BUTTON
compartment is open, the pressing of
LOADING BUTTON
With the power ON, press this
button to open the turntable
compartment.
• The compartment
open if the
STAND-BY.
If the button
a record is
record will
compartment
INDICATOR
switch is turned ON, the side A indi-
If necessary,
voltage
do it
will not
power is on
is pressed while
playing, the
stop and the
will open.