Sharp RP-103H Bedienungsanleitung Seite 15

CLEANING THE APSS
The APSS sensor is contained within the cartridge.
• After long periods of use, dust or dirt on the APSS sensor can cause malfunctions.
CLEANING THE CABINET
When the cabinet becomes dirty,
in diluted detergent. Then use a dry
Do not use chemical cloth,
These substances will cause
crack or cause the paint to peel.
SPECIFICATIONS
-NERAL
Power source:
ACI
Power consumption: 19W
Dimensions: Width;
Height;
Depth;
7kg (15.4 lbs.)
Weight:
TURNTABLE
Front loading linear tracking
Type:
matic
DC motor with
Motor:
DC motor
turntable
DC motor (for driving tonearm) x I
Drive system: Belt
33-1/3 rpm and 45 rpm
Speeds :
Wow and flutter:
0.06% (WRMS)
65dB
Rumble:
SENSOR
If it is allowed to become dirty, it cannot function normally.
clean with a soft cloth
cloth to wipe dry.
benzine or thinner for cleaning.
the cabinet to discolor, lose luster,
IOV, 220V or 240V 50/60Hz
330 mm (13")
106mm (4-3/16")
340mm (13-3/8")
fully
FG (for platter drive)
(for opening and closing
compartment) x I
drive
(DIN 45 507)
(DIN "B")
Remove the styluses as explained
MENT", page 10.
With a very soft hair brush, or photographic
etc., clean off dust and dirt.
Replace styluses and the two covers.
LUBRICATION
dipped The unit has been lubricated
any further lubrication.
TONEARM
Type:
Effective length;
Tracking error angle:
CARTRIDGE
Type:
Frequency response:
auto-
Output:
Channel separation:
Tracking force:
Impedance:
Compl iance :
Replacement stylus:
SHARP reserves the right to make design and specification
changes for product improvement without
11
in ' 'STYLUS
— use blower,
at the factory and does not need
Dynamic balanced linear tracking
70mm (2-3/4")
±0.20
VM type
20Hz — 20,000Hz
3 mV (I kHz, 50mm/sec.)
20dB
3 g (recommended)
47 k ohms
5 x 10-6 cm/dyne
STY.133
prior notice.
REPLACE-
arm