Sharp RP-103H Bedienungsanleitung Seite 13

APSS SENSOR LEVEL
The APSS sensor level control,
compartment, adjusts the sensitivity
device. It should normally be set at the "N"
non-standard records presenting difficulties
switched to either •'H" or ' 'L".
• For
vals
setting the control at "H".
L N
SENSOR
EPEATED
REPEAT
The illustration below shows repeating side A.
Cartridge
The illustration below shows repeating both sides A and B.
Cartridge
Record (side B)
CANCELLING THE REPEATED PLAY FUNCTION
There are 2 ways as described below.
Press the REPEATbutton again,andthe REPEATindicator will go out:
• When playing one side, the record
will finish playing the side and stop.
Press the PLAY/CUT button and the record play will stop immediately.
CONTROL
located on the turntable
of the interval sensing
position, but with
for APSS it can be
records with very narrow
between recorded portions,
PLAY
REPEAT
Play
Record
Play
Record (side A)
Play
Cartridge
When
record will stop when the reverse of
the side being started on is finished
playing.
L
SENSOR
inter-
try
For normal-operation
With normal records
with the sensor at '*H"
• using the REPEAT button will allow listening to one side,
both sides or a single programme
• Even during playing, pressing the REPEAT button will allow
selection of the repeat feature.
REPEATING ONE
Press the REPEAT button
(page 5)
(side A)
REPEATING BOTH
Pressthe REPEAT button and set to both sides play mode.
(page 5)
repeating both sides, the
9
• For records with frequent
signals and rough groove
setting the control at "L".
be sure to have the control set at '
the APSS may not function
or L
repeatedly.
SIDE
and set to the one-side play mode.
SIDES
When repeating programmed selec-
tions, the record will stop after the
last piece in the
been played.
strong
pitch, try
properly
memory has