Configuration; Programming; Programming Track - Decoderwerk 80202 Benutzerhandbuch

Configuration

Programming-on-M ain
The decoder can be configured directly at its
◆
place of use from a DCC control center using
Programming-on-Main (PoM).
All CVs can be updated in the process.
◆
The control center must support
◆
PoM for accessory decoders.
To carry out programming in programming-
◆
on-main mode,
documentation for the control panel used.

Programming track

The decoder can be configured on a
◆
DCC programming track.
All CVs can be read and written via direct
◆
mode.
To carry out programming on the
◆
programming track, please refer to the
documentation for the control center used.

Programming

please refer to the
When configuring using programming on-
◆
main, CVs can only be updated but not read.
There is no feedback about updating a
◆
CV.
It is therefore advisable to check a CV
◆
update immediately.
Changes to the CVs of the decoder are
◆
immediately, no restart of the decoder is
necessary.
The possible values of a CV value are checked
◆
during a write access.
If an attempt is made to write a value to a CV
◆
that is outside the possible values, the write
access is not executed and no confirmation is
sent.
Changes to the CVs of the decoder are
◆
immediately, no restart of the decoder is
necessary.
11