Decoderwerk 80202 Benutzerhandbuch Seite 32

Configuration
Switching time
The switching time of the output can be
◆
configured.
The configured value is multiplied by 1 ms
◆
per step.
Switching pulses from 1ms to 255ms are
◆
possible in increments
Inversion
If an output is inverted, the green and red
◆
connections are reversed.
Monoflop
If monoflop is activated, the motor returns to the
◆
previous position after switching.
Starting position
You can configure whether the motor should
◆
move in a defined direction when the decoder
is started.
Condition
You can configure whether the output should
◆
be restored when the decoder is started.
Outputs
1 second corresponds to 1,000 milliseconds
◆
The default value of 3 means a switching time
◆
of 3ms per step
The default number of steps is (5 * 256)+ 180=
◆
1460
Steps. 1460 * 3ms= 4380 ms, i.e. approx. 4.4 sec
switching time of the motor.
For example, counter-rotating points can be
◆
can be switched with the same address.
For example, fall-back switches
◆
can be simulated.
Connection
The last selected output connection is saved
◆
here.
This allows the lamp to be restored after
◆
a power interruption.
become
14