Decoderwerk 80202 Benutzerhandbuch Seite 26

Commissioning
Connecting the turnout lantern
Please follow the installation instructions for
◆
the turnout lantern first.
The polarity must be observed when
◆
connecting the turnout lantern.
The supply cables of the turnout lantern
◆
must be soldered to the connections of the
decoder.
It may be advisable to shorten the supply
◆
cables accordingly.
K1 and K2 contact inputs enable
manual triggering or switching in
analog mode. Simply switch
K1/K2 to GND or the digital track
for triggering.
Connect outputs
To solder the supply cables, you should
◆
remove the decoder from the turnout, as the
heat generated during the soldering process
can damage the mounting pin of the turnout.
can.
The turnout lanterns can be switched on and
◆
off using normal turnout commands.
The status of the turnout lanterns is
◆
saved and displayed when the decoder
is started.
restored.
8