diagral RP550 Handbuch Seite 59

Only switch on the power to the receiver after closing it.
Carry out real tests to check that the control receiver works according to the choices made in the
"Configuration" chapter.
WHAT DO I DO IF...?
The control receiver does not work as you expected:
Switch off the power supply, open the front panel and disconnect
Check that the device to be controlled (light, flashing light, etc.) works properly without the control
1
receiver.
Carefully check the customised installation radio code.
2
Check that the microswitches are correctly positioned and pushed as far as they will go accor-
3
ding to the choices made in the "Configuration" chapter.
If your receiver controls a device likely to generate interference (flashing light, neon, etc.), check
4
that the distance between the control receiver and the device is greater than 1.5 m.
Check that the receiver is more than 5 m from the control panel, the telephone
5
dialler, the alarm siren and any other control receiver.
REAL TESTS
the device to be controlled.
59
GB