diagral RP550 Handbuch Seite 54

CONFIGURATION
Configure the operating mode bar microswitches according to the application required.
Warning: one application per receiver.
Application 1 - Control lighting (or a 230 V electric device)
You want to...
Activate a light (or an electric
device) for 3 minutes in the event
A
of break in, fire, tamper-proofing
or emergency call.
Activate a light (or an electric
device) for 3 minutes with the
B
LIGHT button on your keypad
or remote control (timer mode)
Activate and deactivate a light (or
an electric device) with the LIGHT
C
button on your keypad or remote
control without time limit (remote
interruption mode)
A
+ A + B
B
A
+ A + C
C
The function described below can be selected with application 1.
Give confirmation of the OFF or
COMPLETE OPERATION (or
+
GROUPS A + B OPERATION)
order for your system
(application 3).
Position of the
microswitches
Put microswitch 5 in
this position without
changing the position
of the other micros-
witches.
54
Operation
The light is switched off either
automatically after 3 minutes or
by sending the OFF command
The light is switched off after 3
minutes.
This timer is reset by pressing the
LIGHT button again on the key-
pad or remote control.
The light is switched off by pres-
sing the LIGHT button again on
the keypad or remote control.
A + B
If the light is activated by the Light
button, it cannot be deactivated
by the OFF command.
A + C
If the light is activated by the Light
button, it cannot be deactivated
by the OFF command.
Brief activation (2 sec) of the light
(or electric device) each time an
Off or Complete Operation (or
Groups A + B Operation) order is
sent. If the light is already on,
confirmation is given by switching
it off for 2 sec.
GB