Troubleshooting; Installation; Safety; General Safety Instructions - STIEBEL ELTRON CON 10 S Bedienung Und Installation

INSTALLATION

Troubleshooting

7. Troubleshooting
Problem Cause
The appliance does Temperature set too low
not heat up. on the appliance.
No power supply.
Overheating. The high
limit safety cut-out has
tripped.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
INSTALLATION
8.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
8.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
WARNING Electrocution
Install the appliance in such a way that control equipment
cannot be touched by a person in the bath or shower.
Material losses
- Fit the appliance to a vertical wall that is heat-resist-
ant to at least 90 °C.
- Maintain the minimum clearances to adjacent ob-
jects.
- Never install the appliance directly below a wall
socket.
Note
The power cable must only be replaced (for example if
damaged) by a qualified contractor authorised by the
manufacturer, using an original spare part.
8.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
www.stiebel-eltron.com
remedy
Check the selected room
temperature. Adjust if nec-
essary.
Check the RCD and the fuse/
MCB in the fuse box.
Remove the cause. After
cooling down for a few min-
utes, the appliance restarts
automatically.
9.

Appliance description

9.1

Standard delivery

The following are delivered with the appliance:
- 1 wall mounting bracket
- 1 fixing bracket
9.2

Accessories

CON 15-30 S | CON 15-30 ZS:
- Towel holder

10. Preparations

10.1 Minimum clearances

a
b
≥100
≥250
≥10
11. Installation
f The correct hole spacing for the wall mounting bracket is f
provided in the dimensioned connection drawing (see chap-
ter "Specification").
f Secure the wall mounting bracket with suitable fixing mate- f
rials. The horizontal and vertical slots in the wall mounting
bracket enable alignment if drilled holes are not completely
accurate.
f Hook the appliance into the wall mounting bracket. f
f Secure the appliance with the mounting bracket and one f
screw to prevent unintentional unhooking. Hook the fixing
bracket into the back panel of the appliance from below.
Towel holder (CON 15-30 S | CON 15-30 ZS)
f Guide the towel holder from above over the wall mounted f
appliance.
f Insert the left and right-hand ends of the towel holder into f
the mounts provided for this purpose in the back panel of the
appliance.
CON 10-30 S | CON 10-30 ZS |
a
≤ 150  b ≥ 250
a b
≤ 200  ≥ 500
≥100
15