Device Wiring - Tell 4G.in6.R2 Kurzleitfaden Für Installateure

7. Check the installation environment to avoid weak signal and other problems
(strong electromagnetic interference, high humidity).
8. Connect the antenna to the GSM socket.
9. Do the wiring according to the wiring diagram below.
10. Connect the device to the power supply (12-30V DC or 12-24V AC,
minimum 500mA).
Attention! Do NOT connect the metallic part of the antenna connector or
the terminals of the device directly or indirectly to the protective ground,
because this may damage the device!
Attention! Do NOT use the GND terminal as a negative input for powering
the device, because this can lead to damaging the components!
-> Chapter 2 of the Installation and Application Manual.

DEVICE WIRING:

The product has six contact inputs and two relay outputs, which can be
configured in the programming software for the task at hand.
Inputs:
The NO and NC dry contacts should be connected between the selected input
(IN1-IN6) and the GND terminal. The input type (NO or NC) can be configured
in the programming software.
Outputs:
The OUT outputs have NO, NC, and COM terminals with potential free (dry)
contacts. The relay output terminals support a maximum load of 1A @ 24V DC.
2