tell 4G.IN6.R2 Kurzleitfaden Für Installateure Seite 7

Smart Module MINI – Quick Guide
Configuring events:
The events are classified into two groups that need to be configured separately.
 Inputs and Input events:
The type and sensitivity of the inputs can be set in the Inputs menu. A state
change on a contact input can generate an event, upon which the device can
perform various actions. To use this option, you must add the input event you
want to use in the Input events menu by clicking on the Add new
Configuring an input event after adding it:
 Enter the Name and select the Type of the event.
 Select the Input.
 Enter the Event code, Partition and Zone.
 Select the Notification template.
 Service events:
The product has various built-in service events on which the device can perform
various actions. To use this option, you must add the service events you want to
use in the Service events menu by clicking on the Add new
Configuring a service event after adding it:
 Enter the Name and select the Type of the event.
 Select the Event from the list.
 You can change the Event code, Partition and Zone if needed.
 Select the Notification template.
Assigning notifications and controls to events:
You can configure notification and output control actions for any event.
Available actions:
 Output control (monostable, bistable, pulse series, or state change).
 Voice call with customizable voice messages.
 IP-based reporting to CMS (SIA DC-09, TELLMon, TEX).
 DTMF-based reporting to CMS (SIA DC-05).
 SMS sending.
 E-mail sending.
 Push message with camera picture option.
Attention! To receive Push messages, you must register the device in the
TELL Control Center mobile app.
-> Chapter 5 of the Installation and Application Manual.
7
button.
button.