Yamaha TTR125 Fahrer- Und Wartungshandbuch Seite 536

STEERING
4. Install:
Lower bracket 1
G
NOTE:
Apply the lithium soap base grease on the
bearing.
5. Install:
Lower ring nut 1
G
Rubber washer
G
Upper ring nut
G
Special washer
G
Tighten the ring nut using the steering
nut wrench 2.
NOTE:
Install the lower ring nut with its larger cham-
fered portion a facing downward.
Refer to "STEERING HEAD INSPEC-
TION AND ADJUSTMENT" section in
the CHAPTER 3.
6. Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
7. Install:
Upper bracket 1
G
Steering stem nut 2
G
Starter knob bracket 3
G
NOTE:
Do not tighten the steering stem nut yet.
8. Install:
Front forks 1
G
NOTE:
Temporarily tighten the pinch bolts (lower
G
bracket) 2.
Do not tighten the pinch bolts (upper bracket)
G
yet.
5 - 56
CHAS
20 Nm (2.0 m · kg, 14 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)