Flexit Motion Bedienungsanleitung Seite 48

User guide
Settings
The fan is set up at the factory ready for use and no additional
settings are required.
Any adjustments that may be needed can be made on the
fan's control panel or using the remote control provided.
The remote control has a range of 3 metres. Holding it at
right angles to the fan produces the best signals. Signals are
acknowledged with a beep. If no beep is heard, go closer and
try again.
SILENT mode speed control
Press switch "3CP" and "4CP" on the fan's control panel, or
switch "4RC" on the remote control.
To see the speed setting, press switch "3CP", "4CP" or "4RC"
once.
MAX mode speed control
Press and hold in switch "7CP", then press "3CP" and "4CP" on
the fan's control panel or "5RC" on the remote control.
To see the speed setting, press and hold in "7CP" and press
"3CP" or "4CP" once at the same time. To see the speed
setting with the remote control, press "5RC".
Mode selection for moisture extraction
MAX mode is the default setting for extraction.
The mode can be changed between SILENT and MAX by
pressing in switch "1CP" on the control panel or pressing
switches "2RC" (SILENT) and "3RC" (MAX) on the remote
control. MAX mode provides the best extraction. SILENT mode
is quieter.To see the mode setting, press switch "1CP" once.
1RC
2RC
4RC
6RC
8RC
9RC
10RC
SILENT
48
5RC
S ILE NT
3RC
MAX
7RC
ON/OF F
PAUS E
MOV E
T IME R S E T T ING S
11RC
ON/OF F
24 H
T E MP E R AT UR E S E T T ING S
MAX