Unpacking And Positioning; Pre-Installation Requirements - Pkm In5-Fzf Beschreibung

CAUTION! To avoid any damage, the sandwich layer and adhesive
must resist heat.
The customer is responsible for the installation. If the manufacturer´s help is
needed to repair any damage due to improper installation, this repair work is not
covered by the guarantee. Improper installation may cause serious personal
injuries and/or property damage. The manufacturer cannot be held liable for such
injuries or damages.

2.1 Unpacking and positioning

1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
WASTE MANAGEMENT
2. The appliance may be equipped with a transport-protection. Be very careful and
do not use any aggressive or abrasive detergents to remove residuals of the
transport-protection.
3. Check that the appliance and the power cord are not damaged.
4. Install the appliance in a dry and well-ventilated place.
5. Connect the appliance to a dedicated socket only.
6. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise, the insulation of the electrical system will be damaged.
7. Connect the appliance to the mains properly.

2.2 Pre-installation requirements

The installation of the induction hob must meet the safety
requirements as well as the legal rules and regulations.
➢ The worktop must be rectangular and plane and made of heat-resisting material.
Structural elements should not interfere with the installation area.
➢ The thickness of the worktop for the installation of the induction hob must be at
least 30 mm.
➢ The wall sat the induction hob should be covered with heat-resistant material, e.g.
ceramic tiles.
➢ During operation of the induction hob, adjacent furniture or housing and all
materials used for installation must be able to resist a temperature of min. 85 °C
above the ambient temperature of the room the appliance is installed in.
➢ The power cable must not come into contact with cabinet doors or drawers.
➢ The appliance must be supplied with an adequate flow of fresh air from outside
the cabinet to the base of the induction hob.
➢ If the induction hob is installed above an oven, the oven must be equipped with
a cooling system.
.
~
55
~