Memory Card (Optional) - Pixsys Atr243 Bedienungsanleitung

7.8 Memory Card (optional)

Parameters and setpoint values can be duplicated from one controller
to another using the Memory card.
There are two methods:
?
With the controller connected to the power supply
Insert the memory card when the controller is off.
On activation display 1 shows
(Only if the correct values are saved in the memory card). By
pressing the
key. The controller loads the new data and starts again.
?
With the controller not connected to power supply.
The memory card is equipped with an internal battery with an
autonomy of about 1000 uses.
Insert the memory card and press the programming buttons.
When writing the parameters, the led turns red and on completing the
procedure it changes to green. It is possible to repeat the procedure
without any particular attention.
key display 2 shows
and display 2 shows
, then confirm using the
RED LIGHT: waiting for programming
GREEN LIGHT: done
LED ROSSO: acceso in programmazione
LED VERDE: programmazione eseguita
17