VEVOR RP9563 Originalanleitung Seite 6

so that the compressor outlet pressure is set lower than the maximum operating
pressure of the tool. Before starting the compressor, pull the ring on the safety valve
to make sure the valve moves freely. Drain water from tank after each use. Do not
weld or repair tank. Relieve all pressure in the hose before removing or attaching
accessories.
WARNING!
Potential hazard that will result in serious injury or loss of life.
• Always ensure that the work piece is firmly secured leaving both hands free to
control the tool.
• Always keep your air tool clean and lubricated. Daily lubrication is essential to
avoid internal corrosion and possible failure.
• Do not overload the tool. Allow the tool to operate at its optimum speed for
maximum efficiency. Excessive overload can cause the tool casing to split, and may
also lead to excessive wear on moving parts and possible failure.
• Use only the light weight coil hoses. For connecting the tool to the compressor
coupling. Do not fit quick change couplings onto the tool, as the vibration can lead to
damage or failure of the coupling.
• Always ensure that the tool has stopped before connecting it to the air supply.
• Verify that grinding accessories that are used with this tools are rated at or above
the tool's speed rating (6000RPM).
• Failure to properly match the accessory to the tool could result in serious personal
injury.
• Always ensure that the accessories are rated/ designed for use with the tool.
• Ensure that the accessories are correctly and securely fastened before connecting
the tool to the air supply.
• Locate the compressor in a well-ventilated area. For cooling, at a minimum of
12"(31cm) away from the nearest wall.
• Protect the air hose and the power cord from damage and puncture. Inspect them
for weak or worn spots every week,and replace them if necessary.
• Always wear hearing protection when using the air compressor. Failure to do so
may result in hearing loss.
• Do not carry the compressor while it is running.
• Do not operate the compressor if it is not in a stable position.
- 5 -