VEVOR P3 PRO Originalanleitung Seite 26

7.2.3 Use the control screen to manually move the laser head to the desired
engraving position (see Figure 1 below).
7.2.4. Click "Set as Bottom Left" to set the current position as the origin. See
Figure 3 below.
7.2.5 Tap "Start". After the file is parsed, the machine will automatically begin
engraving (see Figure 4 below).
7.2.6 If a power outage occurs during engraving, when power is restored, the
screen will display "Unfinished engraving task detected". Tap "Confirm", and the
machine will parse the coordinates and resume engraving from the point where it
was interrupted.
- 25 -