EN
G E T T I N G TO K N O W YO U R A I R P U R I F I E R
Note: See inside cover.
A. Check Filter Indicator
B. Fan Speed Indicators
C. Control Button
D. Air Outlet
E. Air Inlets
F. Aroma Pad
G E T T I N G S TA R T E D
IMPORTANT:
•
The AC power adapter comes stored inside the air purifier.
•
You must remove the plastic from the filter before using.
1.
Remove all packaging, including any tape on the aroma box.
2.
Rotate the top half of the air purifier anticlockwise and remove it from the bottom half.
3.
Remove the filter and AC power adapter from inside the air purifier. Remove all plastic packaging from the
filter. Place the filter back into the air purifier.
4.
Place the top half of the air purifier directly back onto the bottom half of the air purifier. Rotate clockwise
to secure both halves in place.
5.
Connect the AC power adapter to the air purifier. Plug into an outlet.
6.
To allow air to circulate freely in and out of the air purifier, there should ideally be 38 cm / 15 inches of
clearance on all sides of the air purifier.
U S I N G YO U R A I R P U R I F I E R
WARNING: Make sure the air outlet and the air
inlets are not blocked. This may cause the air
purifier to overheat and stop working.
1.
Tap the Control Button to turn on the air purifier.
2.
Optionally, tap the Control Button repeatedly to
change fan speed between I, II, and III.
Note: The display lights will automatically
turn off after 60 seconds of inactivity.
3.
Press and hold the Control Button for 3
seconds to turn the air purifier off.
Essential Oils
Do not add essential oils to the filter or the fan. The
filter will be damaged by the oil and will eventually
release an unpleasant smell. Only add essential oils
to the aroma pad, located in the aroma box near
the top of the air purifier.
Note: Essential oils are not included.
Adding Essential Oils
1.
Push in the aroma box and pull it out.
2.
Add 5–7 drops of essential oil to the aroma pad.
3.
Place the aroma box back into the air purifier.
Note: Do not mix essential oil blends. Clean
the aroma pad before using a new essential oil
blend (see
Cleaning the Aroma
4
G. Aroma Box
H. Air Purifier Bottom
I.
J. AC Power Adapter Input
K. 3-Stage Filter
L. AC Power Adapter
[Figure 2.2]
[Figure 2.3]
[Figure 2.4]
Humidity
Moisture may damage the filter. This air purifier
should be used in an area with a humidity level
below 85% RH. If you use the air purifier in
excessively humid areas, the surface of the filter
may become mouldy.
About the Filters
The air purifier uses a 3-stage filtration system to purify air.
Note: See [Figure 2.6].
A.
B.
C.
Pad, page 6).
Air Purifier Top
Note: Water or moisture will allow mould to
grow. To solve a mould problem, get rid of the
source of the moisture and clean up the mould.
Air purifiers cannot solve an existing mould
problem, and can only remove airborne mould
spores and reduce odours.
Pre-Filter
•
Captures large particles such as
dust, lint, fibres, hair, and pet fur.
•
Maximises the filter's life by protecting it.
Main Filter
•
Traps at least 99.97% of airborne
particles 0.1-0.3 microns in size.
•
Traps airborne particles such as fine
dust, smoke particles, and allergens
such as pollen and pet dander.
Activated Carbon Filter
•
Physically adsorbs smoke, odours, and fumes.
[Figure 2.1]