About The Filters; Care & Maintenance; Cleaning The Filters; Replacing The Filters - Levoit LV-PUR131 Bedienungsanleitung

EN
A B O U T T H E F I LT E R S
This air purifier uses a 3-stage filtration system to purify air.
A. Fine Preliminary Filter
• Captures large particles such as
dust, lint, fibres, hair, and pet fur.
• Maximises the life of the True
HEPA Filter by protecting it.
B. True HEPA Filter
• Removes at least 99.97% of
airborne particles 0.3 micrometres
(µm) in diameter.
• Filters small particles such as
mould spores, tiny dust particles,
parts of smoke, and allergens such
as pollen, dander, and mites.
C. High-Efficiency Activated Carbon Filter
• Physically adsorbs smoke,
odours, and fumes.
• Filters compounds such as
formaldehyde, benzene,
ammonia, hydrogen sulphide,
and volatile organic compounds
(VOCs).
10
C A R E & M A I N T E N A N C E
Cleaning the Air Purifier
Wipe the outside of the air purifier with a dry
cloth. Do not clean with water or any other
liquid, to avoid risk of electric shock.
Check Filter Indicator
The Check Filter Indicator will light up as a
reminder to check the filters. Depending on
how often you use the air purifier, the indicator
should turn on within 6–8 months. You may not
need to change your filters yet, but you should
check them when the indicator light turns on.
Reset the Check Filter Indicator by pressing the
black Filter Indicator Reset Button in the vent on
the side of the air purifier (see page 13).

Cleaning the Filters

A. The Fine Preliminary Filter should be
cleaned once a month to increase
efficiency and extend the life of your
filter. Clean the Fine Preliminary Filter
using a brush or vacuum hose to
remove hair, dust, and large particles.
B. Do not clean the True HEPA Filter. Fine
dust or bacteria may be released back
into the air if cleaning is attempted. Only
clean the Fine Preliminary Filter.
C. The Activated Carbon Filter does not
require cleaning.

Replacing the Filters

1. Unplug the air purifier, then remove the
back cover.
2. Remove the old filters and properly
dispose of them.
3. Unwrap the new filters. Place the
Activated Carbon Filter inside the
housing. Make sure the pull tabs are
facing out.
4. Install the Fine Preliminary/True HEPA
Combination Filter into the housing.
Make sure the pull tabs are facing out.
5. Replace the back cover. The air purifier
will not turn on unless the back cover is
replaced correctly.
6. Reset the Check Filter Indicator (see
page 13).
A B
C
EN
11