Sony VPL-HW55ES Bedienungsanleitung Seite 67

3D video images
Symptom
The video image does not
seem like 3D video images.
Others
Symptom
The fan is noisy.
The lens shift cannot be
adjusted.
The projector and
connected equipment turn
On/Off, play back, and
operate at the same time.
Cause and Remedy
c Check if the 3D glasses are turned on (1 page 33).
c Make sure that the battery in the 3D glasses is charged.
c Check if the input source is HDMI.
c Set "2D-3D Display Sel." to "Auto" or "3D" (1 page 55).
c Check if the input signals are compatible 3D signals (1 page
81).
c If no 3D signal is input from the 3D equipment connected to the
projector, restarting the connected 3D equipment may solve the
problem.
c When the viewing or projector position is too far from the
screen, the 3D glasses may not be able to display the images
properly (1 page 34).
c If you use the optional 3D Sync Transmitter, check that it is
placed within the specified range (1 page 24).
c The screen size is not appropriate. Set the zooming
magnification to low or watch the image from farther away from
the screen (1 page 87).
Cause and Remedy
c Check the setting of "Cooling Setting" in the Setup
(1 page 53)
c Make sure that the room temperature is not too high.
c Check the installation conditions. (1 page 13)
The number of fan rotation increases to maintain the product
reliability of the projector's components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
c The lens shift cannot be adjusted over the range of movement.
Adjust the lens shift within the range of movement (1 page
19).
c "Control for HDMI", "Device Auto Power Off", and "PJ Auto
Power ON" are set to "On". Set them to "Off".
For details, see "HDMI Setting" (1 page 56).
menu.
67
GB