Cleaning The Device; Storing The Device; Disposing Of The Device - Beurer FT 100 Gebrauchsanweisung

12. Cleaning the device

• The measuring sensor is the most sensitive part of the thermometer. Be very careful with the meas-
uring sensor when cleaning the device.
• Do not use any harsh cleaning products.
• Always observe all safety notes for users and the device.
w 3. Warnings and safety notes
Clean the measuring sensor after each use. Use a soft cloth or cotton bud that can be moistened with disinfect-
ant or 70% alcohol.
To clean the entire device, please use a soft cloth slightly moistened with a mild soapy solution. Under no circum-
stances may liquid enter the device.
Do not use the device again until it is completely dry.
13.

storing the device

The device must not be stored or used at an excessively high or low temperature or humidity (w 15. Technical
data), in sunlight, in association with an electrical current or in dusty locations. Measurement inaccuracies can
otherwise occur.
If prolonged storage is planned, you should remove the batteries.

14. Disposing of the device

For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the device at a suitable local collection or recycling point. Dispose of the device in accordance with
EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
41