Registration (Pairing) Rdp-21 In The Exta Life System - Zamel Exta Life Rdp-21 Bedienungsanleitung

REGISTRATION (PAIRING) RDP-21 IN THE EXTA LIFE SYSTEM

In order to register RDP-21 in the system, it is necessary to connect the EXTA LIFE controller and
to install the EXTA LIFE mobile application. The receivers must be connected to 230 V AC. They
are remembered in the system only after they have been properly paired with a controller. To do it
carry out the following steps:
1. Activate the application and enter the De-
vice screen.
2. Choose the receiver tab and press „+"
to start the searching process of receivers
installed in the system. It lasts no longer
than 60 seconds and can be stopped by
means of the „Stop" push-button. All re-
ceivers located within the controller are
automatically displayed in a list form with
a default icon, default name including
the receiver's name (RDP-21) + ID serial
number assigned to this receiver
3. After searching has been completed
press the 'TEST' button to quickly locate
the receiver (after the TEST push-button
has been pressed, the dimmer's output is
switched on as long as the TEST push-
button is pressed).
4. By marking fields next to the 'TEST'
push-button, we choose receivers to be
paired with the EXTA LIFE controller. It is
possible to mark more than one receiver.
5. Press the 'PAIR' push-button to pair the
marked receivers. After a while the receiv-
ers are registered in the system and are on the list in the Receivers
tab  .
6. After pairing, a default icon is assigned to the RDP-21 receiver.
7. The receivers after pairing can be controlled at once by means of ap-
plication buttons. The receiver's mode (switched on / switched off) is
signalled by an icon and a switch position. Current lighting luminous
flux intensity value is defined by the "Brightness level" parameter
given in %.
8. The receivers can be paired individually – press the "PAIR" push-
button and assign a new name to a receiver. In case a larger number
of receivers are paired, they are automatically saved with default
names.
9. After pairing, it is possible to add an individual name and icon (from
the icon base) to each RDP-21 receiver.
10. Only paired receivers can be used in the system in a further configu-
ration process (assigning a user, a category, building scenes, time
and logic functions).
CAUTION: In order to register receivers successfully in the system (mainly if there is a larger
number of receivers), it is necessary to activate the device pairing method several times and
pair the ones that were found.


 .
 ,




