Assigning Push-Buttons In The 1 Push-Button Mode - Zamel Exta Life Rdp-21 Bedienungsanleitung

PROGRAMMING EXTA LIFE RADIO TRANSMITTERS
• Green "STATUS" LED signals the programming procedure is ongoing.
• Successful completion of a particular activity is signalled by a flashing (3-times) green STATUS
LED.
• During operation the STATUS LED signals transmission / receiving.
CAUTION! It is possible to assign up to 96 push-button pairs to the RDP-21 receiver's mem-
ory in subsequent iterations during programming. It is for example:
• up to 48 push-buttons in the 1 push-button or time mode,
• up to 48 push-buttons in the 2 push-button mode (with a division into 24 „ON" push-
buttons and 24 "OFF" push-buttons),
• up to 12 (4 push-button) transmitters in comfort mode.
• Push-buttons can be random (they must be within the same transmitter), which gives a huge
flexibility during programming and then control. A receiver operates properly only with push-
buttons assigned to it during the programming procedure.
• Push-buttons can be assigned to RDP-21 directly by means of the PROG push-button (the ac-
cess to this receiver is required then) or remotely (without an access to the receiver) by means
of a mobile application and EXTA LIFE controller.
CAUTION!
1. „STATUS" LED signals receiving to all transmitters, including those not programmed with a dim-
mer. However, it is not possible to control the device by means of those transmitters.
2. The 2 push-button and comfort modes are recommended to control few dimmers at the same
time by means of one transmitter only. The 1 push-button mode should not be used, as it can
jitter dimmer's operation during control.
DIRECT PROGRAMMING BY MEANS OF PROG. PUSH-BUTTON
To assign radio transmitters directly to a receiver, use the receiver's PROG. push-button.

ASSIGNING PUSH-BUTTONS IN THE 1 PUSH-BUTTON MODE

(e.g. 2 push-button remote control P-457/2)
1. Press the PROG. push-button shortly (1s). in a receiver –STATUS LED switches on green.
2. In < 5 sec. press the button that should realise control in the 1 push-button mode (for example
"1").
3. STATUS LED switches off and switches on green again.
4. In < 5 sec. release the button that is assigned in the 1 push-button mode (for example "1").
5. The STATUS LED flashes green (3 times) to signal the push-button has been assigned correctly.