ZAMEL exta life RDP-21 Bedienungsanleitung Seite 24

FUNCTIONALITY
1. The RDP-21 dimmer can be simultaneously controlled by:
a. EXTA LIFE system transmitters:
• switching on the lighting to the last adjusted level,
• switching off the lighting,
• lighting luminous flux intensity adjustment (longer pressing of the transmitter's push-button),
• time switching on,
• various operating modes (1 push-button, 2 push-button, time, comfort),
b. EXTA LIFE mobile application, after pairing with a controller:
• switching on the lighting to the last adjusted level,
• switching off the lighting,
• lighting luminous flux intensity adjustment by means of a slide (% luminous flux intensity value),
• a possibility of switching on the dimmer for pre-set time,
• a possibility of activation of 4 favourite settings (maximum),
c. external input:
• switching on the lighting to the last adjusted level,
• switching off the lighting,
• switching on the lighting to 100%,
• lighting luminous flux intensity adjustment (only for monostable push-buttons - longer pressing
of the transmitter's push-button),
• time switching on.
2. Current dimmer mode (switched on / switched off) and current lighting luminous flux intensity are
shown in the mobile application. The dimmer's mode is signalled by means of an icon and by a
push-button position (ON / OFF).
3. It is possible to assign a larger number of push-buttons of EXTA LIFE radio transmitters to the
RDP-21 device – maximum 96 pairs (e.g. 48 transmitters in the 2 push-button mode).
4. Transmitters' push-buttons can be assigned to the RDP-21 dimmer by means of the PROG
push-button or „remotely" by means of the mobile application (without a direct access to a dim-
mer).
5. Few RDP-21 dimmers can cooperate with one transmitter – it enables to control a larger number
of lighting fittings (CAUTION: in this case, the 2 push-button mode is recommended) or an
independent control from different places.
6. A dimmer can be simultaneously paired only with one EXTA LIFE controller.
7. Push-buttons added to a dimmer can be selectively deleted.
8. There is a possibility to delete simultaneously all push-buttons added to a dimmer's memory
(reset to default settings).
9. Basic RDP-21 parameters are configured by means of the mobile application.
10. A remote software update of a dimmer is also possible due to the mobile application (the EXTA
LIFE controller must be connected to the Internet).
APPEARANCE
Output terminal
Input terminal
Power supply terminals L, N
Signalling diode - LED green
(receiving / transmission / mode)
Programming push-button