Time Mode; Comfort Mode - Zamel Exta Life Rdp-21 Bedienungsanleitung

TIME MODE

Only one push-button of a transmitter is used in time mode to control a dimmer. After a short press-
ing of the button, the dimmer's output is switched on with a maximum value of the lighting luminous
flux intensity and it switches off automatically after the programmed time tON1. Pressing the trans-
mitter's push-button during the countdown results in earlier switching off the dimmer's output. The
exception is in case the push-button is pressed during dimming - then the dimmer is not switched
off, but the brightening starts and tON1 time is counted from the beginning (retriggered time). The
tON1 switch on time is programmed in the range from 1 sec. to 18 hrs. In case of RDP-21 dimmer,
it is possible to adjust an independent time for each push-button programmed in time mode, and for
the local input IN, and for the control realised by means of an application.
CAUTION: Zone time or individual times for particular push-buttons can be programmed
directly by a receiver (PROG. push-button) or by means of a mobile application in coopera-
tion with the EXTA LIFE controller.
Time for the local input and time to control by means of the application can be programmed only
by the application.

COMFORT MODE

Comfort mode refers only to transmitters equipped with minimum four push-buttons (e.g. RNK-24,
P-457/4). Functionality of the comfort mode will be presented on the example of RNK-24 transmitter
(assuming that during programming push-buttons 1 and 2 were assigned in the first step and push-
buttons 3 and 4 in the second step):
Push-button „1" – realises only the dimmer's switching
on function to 100% brightness
Push-button „2" – realises only the dimmer's switching
off function
Push-button „3" – short pressing switches on the dim-
mer to the memorised lighting level.
Longer pressing (>2 s) realises the
brightening function to the maximum
level.
Push-button „4" – short pressing of the push-button
switches off the dimmer. Longer press-
ing (>2 s) realises the dimming function
to the minimum level.
• If the dimmer was switched on to 100 % by means of push-button "1", then pressing push-button
"3" shortly causes the dimmers switches to the memorised level.
• If the dimmer was switched on to the memorised level by means of push-button "3", then press-
ing push-button "1" shortly causes the load switches on to 100% brightness.
• In case the dimmer is switched off, then pressing longer push-button "3" causes the dimmer
switches on with a fluent brightening from the minimum level.
CAUTION: Functionality of particular buttons can differ – it depends on the sequence of
assigning them to a dimmer during programming.
1 3
2 4