Memory Deletion - Zamel Exta Life Rdp-21 Bedienungsanleitung

In order to assign remotely selected push-buttons of a transmitter to the RDP-21 device,
the following steps are required:
1. Pair the selected RDP-21 receiver with the controller.
2. Pair the controller with a transmitter, which buttons you want to assign remotely to a receiver.
3. Choose the "Assign a receiver" option by means of a transmitter.
4. From the list of all paired receivers, choose the RDP-21 receiver, the transmitter's push-buttons
will be assigned to.
5. In the 'Operation mode' field, select the mode the transmitter should cooperate with a receiver. In
case of RDP-21 the 1 push-button, 2 push-button, time and comfort modes are possible.
6. Choose the transmitter's push-buttons that will be assigned remotely to a receiver. The number
of push-buttons depends on the selected operating mode. By pressing the "Transmitter preview",
the transmitter with assigned numbers of push-buttons will be displayed.
7. By pressing the "Save" push-button, a transmitter is remotely programmed in a receiver. As a
confirmation, the system displays the following message "Devices have been correctly paired".
It is also possible to assign remotely a transmitter to a receiver by means of a receiver. To do it
choose the "Assign a transmitter" option in the receiver's menu.
RDP-21 MEMORY DELETION
After deleting the whole memory of a receiver, all added push-buttons of transmitters are deleted.
Erasing (deleting) the memory includes the receiver is also unpaired with the EXTA LIFE control-
ler. If the receiver's memory included push-buttons assigned in time mode, then after memory
deletion the individually assigned push-buttons are also deleted. The zone time has a default
setting value - 10 sec. If a user switched off deliberately pairing with the controller (see Switching
off pairing - Broadcast OFF), then deleting the receiver's memory switches on the possibility of
pairing automatically (default setting).
1. Press the PROG. push-button for about 5 seconds –STATUS LED switches on green.
2. After STATUS LED switches off, release the PROG. push-button and in < 5 sec. press it again.
3. The STATUS LED flashes green (3 times) to signal the deleting has been completed.
(restoring default settings)