Assigning Push-Buttons In The 2 Push-Button Mode; Assigning Push-Buttons In Comfort Mode; Assigning Push-Buttons In Time Mode - Zamel Exta Life Rdp-21 Bedienungsanleitung

ASSIGNING PUSH-BUTTONS IN THE 2 PUSH-BUTTON MODE

(e.g. 2 push-button remote control P-457/2)
1. Press PROG push-button shortly (1s). in a receiver –STATUS LED switches on green.
2. In < 5 sec. press the button that should realise the "switch on" function (for example "1").
3. STATUS LED switches off and switches on green again.
4. In < 5 sec. press the button that should realize the "switch off" function (for example "2").
5. STATUS LED switches off and switches on green again.
6. Wait for about 5 seconds to finish the programming procedure, which is signalled by the flashing
STATUS LED green (3 times).

ASSIGNING PUSH-BUTTONS IN COMFORT MODE

This mode is available for transmitters with at least 4 push-buttons
(e.g. 4 push-button remote control P-457/4)
1. Press PROG push-button shortly (1s). in a receiver –STATUS LED switches on green.
2. In < 5 s press the button that should realise the "switch on dimmer to 100%" function (for example
"1").
3. STATUS LED switches off and switches on green again.
4. In < 5 sec. press the button that should realise the "switch off" function (for example "3").
5. STATUS LED flashes and switches on green again.
6. In < 5 sec. press the button that should realize the "switch on dimmer to the last remembered level
/ brighten" function (for example "2").
7. STATUS LED switches off and switches on green again.
8. In < 5 sec. press the button that should realise the "switch off /dim" function (for example "4").
9. The STATUS LED flashes green (3 times) to signal the push-button has been assigned correctly.

ASSIGNING PUSH-BUTTONS IN TIME MODE

(e.g. 2 push-button remote control P-457/2)
1. Press PROG push-button shortly (1sec). in a receiver –STATUS LED switches on green.
2. In < 5 sec. press the button that should be assigned in time mode (for example "1").
3. STATUS LED switches off and switches on green again.
4. In < 5 sec. press shortly this push-button that should be assigned in time mode (for example "1").
5. The STATUS LED flashes green (3 times) to signal the push-button has been assigned correctly.
CAUTION!
Each new push-button assigned to RDP-21 dimmer in time mode operates with the so-called Zone
Time. The default Zone Time is 10 sec. A user can change its value in the range from 1 sec. to 18
hours.