Lower Guard Function; Additional Safety Warnings - Parkside Performance Ppmsa 20-Li A1 Bedienungsanleitung Und Originalbetriebsanleitung

e) Do not use dull or damaged
blad s Unsharpened or improperly
set blades produce narrow kerf
causing excessive friction, blade
binding and kickback.
f) Blade depth and bevel adjusting
locking levers must be tight and
s b o
blade adjustment shifts while cutting, it
may cause binding and kickback.
g) Use extra caution when sawing
into existing walls or other blind
a as The protruding blade may cut
objects that can cause kickback.
˜ Lower guard function
a) Check the lower guard for proper
closing before each use. Do
not operate the saw if the lower
guard does not move freely and
close instantly. Never clamp or
tie the lower guard into the open
osition If the saw is accidentally
dropped, the lower guard may be
bent. Raise the lower guard with the
retracting handle and make sure it
moves freely and does not touch the
blade or any other part, in all angles
and depths of cut.
b) Check the operation of the lower
guard spring. If the guard and the
spring are not operating properly,
they must be serviced before
s Lower guard may operate
sluggishly due to damaged parts,
gummy deposits, or a build-up of
debris.
c) The lower guard may be retracted
manually only for special cuts such
as "plunge cuts" and "compound
cuts". Raise the lower guard by the
retracting handle and as soon as the
blade enters the material, the lower
a d st b
other sawing, the lower guard should
operate automatically.
42 GB/IE
a in t t If
l as d For all
d) Always observe that the lower guard
is covering the blade before placing
t saw down on b n
unprotected, coasting blade will cause
the saw to walk backwards, cutting
whatever is in its path. Be aware of the
time it takes for the blade to stop after
switch is released.
˜ Additional safety warnings
a) Do not allow the ejected cutting
chip come into contact with your
ands You may be injured/cut by
cutting chips ejected with high speed.
b) Do not use the saw above the level
o o ad Doing so will mean you
have inadequate control of the power
tool.
c) Do not use grinding discs with this
ow tool Grinding discs can easily
break and cause personal injury.
d) Use suitable detectors to determine
if there are hidden supply lines or
contact the local utility company
o assistan Contact with electric
cables can cause fire and electric
shock. Damaging gas lines can lead
to explosion. Breaking water pipes
causes property damage.
e) Do not modify the power tool or
o at it w n stationa
suitable for operation as a table saw.
f) S t wo
clamped with clamping devices or in a
vice is held more secure than by hand.
g) Do not use HSS (high-speed steel)
saw blad s Such saw blades can
easily break.
h) Wear safety goggles, hearing
protection and dust mask during
operation.
i) Always use the saw blade intended
for cutting the material that you are
going to cut.
j) Only use the saw blades that are
a d wit a s
than the speed marked on the tool.
o oo An
It is not
i A workpiece
d al o i