Further Safety Instructions For All Saws - Parkside Performance Ppmsa 20-Li A1 Bedienungsanleitung Und Originalbetriebsanleitung

d) Never hold the workpiece in your
hands or across your leg while
cutting. Secure the workpiece to
a stabl lat o
support the work properly to minimise
body exposure, blade binding, or loss
of control.
e) Hold the power tool by insulated
gripping surfaces, when performing
an operation where the cutting tool
a onta t idd n wi in Contact
with a „live" wire will also make
exposed metal parts of the power tool
„live" and could give the operator an
electric shock.
f) When ripping, always use a rip fence
o st ai t d
the accuracy of cut and reduces the
chance of blade binding.
g) Always use blades with correct size
and shape (diamond versus round)
o a bo ol s Blades that do not
match the mounting hardware of the
saw will run off-centre, causing loss of
control.
h) Never use damaged or incorrect
blad was s o bolt The blade
washers and bolt were specially
designed for your saw, for optimum
performance and safety of operation.
˜ Further safety instructions for
all saws
Kickback causes and related warnings
Kickback is a sudden reaction to a
pinched, jammed or misaligned saw
blade, causing an uncontrolled saw to
lift up and out of the workpiece toward
the operator.
When the blade is pinched or jammed
tightly by the kerf closing down, the
blade stalls and the motor reaction
drives the unit rapidly back toward the
operator.
It is important to
id This improves
If the blade becomes twisted or
misaligned in the cut, the teeth at the
back edge of the blade can dig into the
top surface of the wood causing the
blade to climb out of the kerf and jump
back toward the operator.
Kickback is the result of saw misuse and/
or incorrect operating procedures or
conditions and can be avoided by taking
proper precautions as given below.
a) Maintain a
and position your arms to resist
kickback forces. Position your body
to either side of the blade, but not in
lin wit t blad Kickback could
cause the saw to jump backwards, but
kickback forces can be controlled by
the operator, if proper precautions are
taken.
b) When blade is binding, or when
interrupting a cut for any reason,
release the trigger and hold the
saw motionless in the material until
the blade comes to a complete
stop. Never attempt to remove
the saw from the work or pull the
saw backward while the blade
is in motion or kickback may
o Investigate and take corrective
actions to eliminate the cause of blade
binding.
c) When restarting a saw in the
workpiece, centre the saw blade in
the kerf so that the saw teeth are
not n a d into t
saw blade binds, it may walk up or
kickback from the workpiece as the
saw is restarted.
d) Support large panels to minimise
the risk of blade pinching and
i ba Large panels tend to sag
under their own weight. Supports must
be placed under the panel on both
sides, near the line of cut and near the
edge of the panel.
i on t saw
at ial If a
GB/IE 41