Fitting The Attachment; Removing The Attachment; Putting On The Harness; Use - Parkside Performance Pptlba 40-Li C3 Originalbetriebsanleitung

Fitting the blower pipe
♦
housing 3
Fig. B).

Fitting the attachment

Slide the attachment 6
♦
pipe 4
4 must engage in the guide rail 5 on
the attachment 6 .
There are 3 possible positions for the
attachment 6 (see Fig. B).
♦
pipe 4
4 must engage in the guide rail 5 on
u .
nozzle u (see Fig. B).
Removing the blower pipe
♦ 7
pipe 4 and attachment 6 (see Fig. B).

Removing the attachment

Remove the attachment 6 from the
♦
4 by unthreading it from
the guide rail 5 (see Fig. B).
♦
er pipe 4 by unthreading it from the
guide rail 5 (see Fig. B).

Putting on the harness

WARNING!
►
ly across your shoulder and chest.
appliance from your body in case of
danger.
|
4 to the motor
7 engages (see
o
u
o
u
z diagonal-
WARNING!
►
harness z
ance before removing the harness z .
Never use several strap holders or sev-
►
eral shoulder straps at the same time.
►
lease mechanism t to release the ap-
pliance from the harness z .
Place the harness z over one shoulder.
♦
Adjust the strap length so that the snap
♦
♦
to the fastening lug i for attaching the
harness z .
This is located at the top of the appli-
ance (see Fig. B).

Use

Before using the appliance, insert both
2 (see Fig. A) and attach the
harness z .
-
WARNING!
►
ance. Ensure that the appliance is in
sure that the appliance is assembled
aged, the appliance must no longer be
used. Personal protective equipment
and a fully functional appliance reduce
The harness z
nism t
detach the appliance
from the harness z in
a dangerous situation.
In a dangerous situa-
-
-
-
-
z
-