Fitting The Blower Pipe; Fitting The Attachment; Fitting The Flat Nozzle (Optional); Removing The Blower Pipe - Parkside Performance Pptlba 40-Li C3 Originalbetriebsanleitung

Fitting the blower pipe

♦ Attach the blower pipe 4 to the motor housing
3. The lock 7 engages (see Fig. B).

Fitting the attachment

♦ Slide the attachment 6 onto the blower pipe 4.
The knob o on the blower pipe 4 must en-
gage in the guide rail 5 on the attachment 6.
There are 3 possible positions for the attach-
ment 6 (see Fig. B).
Fitting the flat nozzle (optional)
♦ Slide the flat nozzle u onto the blower pipe 4.
The knob o on the blower pipe 4 must engage
in the guide rail 5 on the flat nozzle u.
There are 3 possible positions for the flat
nozzle u (see Fig. B).

Removing the blower pipe

♦ Press the lock 7 and remove the blower pipe
4 and attachment 6 (see Fig. B).

Removing the attachment

♦ Remove the attachment 6 from the blower
pipe 4 by unthreading it from the guide rail 5
(see Fig. B).
Removing the flat nozzle (optional)
♦ Remove the flat nozzle u from the blower
pipe 4 by unthreading it from the guide rail 5
(see Fig. B).
■ 72 │ GB │ MT

Putting on the harness

WARNING!
► Never wear the harness z diagonally across
your shoulder and chest. Only ever wear it
on one shoulder as this allows you to quickly
remove the appliance from your body in case
of danger.
► Never use the appliance without the harness
z. Always switch off the appliance before
removing the harness z.
► Never use several strap holders or several
shoulder straps at the same time.
►
quick-release mechanism t to release the
appliance from the harness z.
♦ Place the harness z over one shoulder.
♦ Adjust the strap length so that the snap hook
is about 10 cm below the hip.
♦ Attach the snap hook of the harness z to the
fastening lug i for attaching the harness z.
This is located at the top of the appliance (see
Fig. B).
The harness z comes
with a quick-release
mechanism t to quickly
detach the appliance
from the harness z in a
dangerous situation.
In a dangerous situation,
press both sides of the
PPTLBA 40-Li C3