Remove/Insert Battery; Fitting/Removing Blower Pipe And Flat Nozzle - Parkside Performance Pptlba 40-Li B2 Originalbetriebsanleitung

your Parkside X 20 V Team
series batteries and chargers.
If warm, allow the battery to cool
before charging.
Do not expose the battery to direct
sunlight for long periods and do not
place it on a radiator (max. 50°C).
1. Remove the rechargeable batteries (2)
from the device, if necessary.
2. Slide the rechargeable batteries (2)
onto the charger (16) up to the stop.
3. Plug the charger (16) into a socket.
4. Once charging is complete, disconnect
the charger (16) from the mains supply.
5. Remove the battery (2) from the
charger (16).

Remove/insert battery

1. To remove the battery (2) from the
device, press the release button on the
battery (2) and pull the battery out.
2. To insert the battery (2), push the bat-
tery (2) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Fitting/removing
blower pipe and flat
nozzle
Never use the leaf blower
without the attachment. There
is a risk of personal injury!
Pay attention to the correct assem-
bly of the blower pipe (4), other-
wise the leaf blower will not start.
Fitting the blower pipe
• Place the blower pipe (4) on the mo-
tor housing (3). The lock (7) clicks into
place.
Fitting the attachment
• Slide the attachment (6) onto the blow-
er pipe (4).
The button (17) on the blower pipe (4)
must slide into the guide rail (5) on the
attachment (6).
There are 3 possible settings for the at-
tachment (6).
The device can be set to your in-
dividual working height via these
3 settings. You should always work
with the blower pipe as close to the
ground as possible.
Fitting the flat nozzle (optional)
• Slide the flat nozzle (13) onto the blow-
er pipe (4).
The button (17) on the blower pipe (4)
must slide into the guide rail (5) on the
flat nozzle (13).
There are 3 possible settings for the flat
nozzle (13).
The device can be set to your in-
dividual working height via these
3 settings. You should always work
with the blower pipe as close to the
ground as possible.
Removing the blower pipe
• Press the lock (7) and remove the blow-
er pipe (4) and the attachment (6).
Removing the attachment
• Remove the attachment (6) from the
blower pipe (4) by sliding it out of the
guide rail (5).
Removing the flat nozzle
(optional)
• Remove the flat nozzle (13) from the
blower pipe (4) by sliding it out of the
guide rail (5).
GB MT
35