Charging The Battery Pack - JVC gc-px100be Grundlagen Benutzerhandbuch

Charging the Battery Pack

Attach the battery pack.
The battery pack is not charged
at the time of purchase.
Open the battery cover (#) after
opening the LCD monitor (!).
Place the battery toward the right
side. Push the battery into the main
unit, and slide in until the battery
clicks into place.
Connect the DC connector.
Cover
CAUTION
Be sure to use JVC battery packs.
If you use any other battery packs besides JVC battery packs, safety and
0
performance cannot be guaranteed.
If malfunctions (overcurrent, overvoltage, transmission error, etc) occur, or if any
0
battery manufactured other than JVC is attempted for battery charge, charging
stops. In these cases, the CHARGE lamp blinks quickly for notification.
You can record or play back videos while the AC adapter is connected. (Battery
0
charging cannot be performed during recording or playback.)
Remove the battery when the unit is to be used for a long time. Performance
of the battery may drop if it is left attached to the unit.
The estimated charging time of the supplied battery pack is approximately 2
0
hour 10 minutes.
The charging time is when the unit is used at 25°C. If the battery pack is charged
0
outside the room temperature range of 10°C to 35°C, charging may take a longer time
or it may not start. CHARGE lamp blinks 2 times in a slow cycle for notification if the
battery charge does not start. Also, please note that the recordable and playable time
may be shortened under some usage conditions, such as at low temperature.
6
AC Adapter To
AC Outlet
Detaching the Battery Pack
Plug in the power.
Charging Lamp
Charging in progress:
Blinks
Charging finished:
Goes out
To remove the battery,
press the battery lock
lever( Q) and slide the
battery(R) .