Technical Data, See „Technical Data" Book; Function Of The Unit; Overview (A); Operating Instructions - Rothenberger ROWELD P 160 Saniline Bedienungsanleitung

17 Avoid unintentional activation. When plugging the tool in, make sure that the switch is
turned off.
18 Use outdoor extension cords. When outdoors, use only extension cords that are approved
and appropriately marked.
19 Be alert. Pay attention to what you do. Approach your work sensibly. Do not use the electric
tool when you are distracted.
20 Check the electric tool for damage. Before using the electric tool, you must inspect safety
equipment or slightly damaged parts carefully to ensure that they work properly and as in-
tended. Check to see that the moving parts operate freely and don't stick, and to make sure
no parts are damaged. All parts must be mounted properly and meet all the conditions for
ensuring trouble-free operation of the electric tool.
Damaged safety equipment and parts must be properly repaired or replaced by a profes-
sional facility, unless otherwise indicated in the user manual. Damaged switches must be
replaced by a customer service facility.
Never use an electric tool whose switch cannot be turned on and off.
21 Caution. Using other insertion tools and accessories may cause injury.
22 Have your tool repaired by an electrical expert. This electric tool meets applicable safety
requirements. Repairs must be made only by an electrical expert using original replacement
parts. Otherwise accidents many occur.
2 Technical Data, see „technical data" book
3

Function of the Unit

3.1

Overview (A)

1 Trimmer unit
2 Heating element
3 Machine housing
4 Movable table
5 Clamping lever
6 Grip bar
7 Safety catch
Welded joints for house installations, chimney renovations and roof drainage systems made of
PE, PVDF and PP pipes with outer diameters of 40 - 160mm/ 1"- 5" can be safely produced with
the machine.
Depending on the version (Version A = clamping plates, knee lever version, Version B =
clamping plates, screw version), clamping elements can be used instead of the support forks for
the exterior clamping positions. Threads are provided for this purpose in the machine base and
in the movable table.
3.2

Operating instructions

In accordance with national or EU ordinances and guidelines, e. g. DVS 2212,
Section I, only duly qualified and authorised personnel are allowed to operate the
ROWELD welding machines!
Only trained and authorised welders are allowed to operate the machine!
3.2.1

Putting into operation

Please read through the operating instructions and safety instructions atten-
tively before you put the butt fusion welding machine into operation!
Do not use the heating element in explosive environments or bring it into
contact with easily flammable materials!
 Put the machine on a level, solid surface.
8 Main clamp Version A
8.1 Adjusting nut
8.2 Tensioning screw
9 Main clamp Version B
9.1 Clamping insert, bracket
10 Support brackets
11 Knob