Use According To Intended Purpose; Residual Risks; Safety Instructions - Mafell LNF 20 Originalbetriebsanleitung

2.8 Use according to intended purpose

The MAFELL biscuit jointer LNF 20 is intended
exclusively for cutting grooves on solid timber,
plywood, particle boards, fibre boards, perspex and
artificial marble for biscuit sizes No. 0, 10, 20, S6,
Simplex and Duplex.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
So as to use the machine as intended, comply with
the operating, maintenance and repair instructions
specified by Mafell.

2.9 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
- Touching the disc cutter outside the support.
- Parts of the disc cutter breaking and getting hurled
out.
- Touching live parts with the housing open and the
mains plug not removed.
- Hearing can be impaired when working for long
periods without ear protectors.
- Emission of harmful wood dusts during longer
operation without extraction.
3

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
General instructions:
- Never work without the protection devices
stipulated for the respective operating sequence
and do not effect any modifications on the machine
that could impair safety.
- Children and adolescents must not operate this
machine. This rule does not apply to young
persons receiving training and being supervised by
an expert.
- Always check before beginning work whether the
protection and work devices are safely attached
and not damaged.
- Consider environmental influences. Do not expose
the device to rain and avoid working near
combustible liquids or gases.
- When operating the machine outdoors, use of an
earth-leakage circuit-breaker is recommended.
- Do not carry the machine by its cable and do not
use the cable to pull the plug out of the socket
outlet.
- Pay attention that the cable is protected against oil
and heat and cannot be damaged by being driven
over, crushed or pulled.
- Damaged cables or plugs must be immediately
replaced.
- Avoid sharp bends in the cable. Especially when
transporting and storing the machine, do not wind
the cable around the machine.
- Store the device in a dry, locked place outside the
reach of children.
Do not use:
- Cracked and misshapen disc cutters.
- Blunt disk cutters as they impose an excessive
load on the motor.
Instructions on the use of personal protective
equipment:
- Always wear ear protectors during work.
- Always wear protective goggles during work.
- Always where a dust mark during work.
Instructions on operation:
- Provide for an unobstructed and slip-proof location
with adequate lighting.
- Before tool changes, making adjustments and
eliminating malfunctions (including the removal of
trapped splinters), pull out the mains plug.
- Do not work on workpieces which are too small or
too large for the capability of the machine.
-16-