Technical Data; Noise Emission Specifications; Vibration Specifications; Scope Of Supply - Mafell LNF 20 Originalbetriebsanleitung

2.3 Technical data

Universal motor, radio and TV
interference suppressed
Input power continuous operation
Cutting depth
Swivel range
Idling speed
Cutting speed at normal load
Hose connector diameter
Weight without mains cable

2.4 Noise emission specifications

Noise emission values determined according to EN 60745-1:
Idling
The noise measurement was recorded using the disk cutter included in the standard equipment.
The values stated do not take into consideration any possible series variances and are not suitable for
determining the rating levels, as these fluctuate in dependence on the time in service, the respective type of
machining and the environmental influences. The noise rating level can therefore only be determined on an
individual basis at the machine user's position.

2.5 Vibration specifications

The typical hand-arm vibration is less than 2.5 m/s

2.6 Scope of supply

Biscuit jointer LNF 20 complete with:
1 disc cutter
1 ejection pipe
1 hose connector
1 dust bag, complete
1 Phillips screwdriver
1 Face wrench
1 carrying case
1 operating manual
1 folder "Safety Instructions"

2.7 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
Sound power level
93 dB (A)
.
2
230 V~, 50 Hz
750 W
19 mm (6 1/4 in./5 3/4 in.)
0 – 90 °
9800
rpm
28.7 m/s
35 mm (1 3/8 in.)
3.2 kg (12.1 lbs)
Workplace-related emission value
82 dB (A)
The machine is equipped with the following safety
devices:
- Protection against contact with the bits
- Large bearing faces of limit stops
- Handles and handle supports
- Hose connector
-15-