PLEASE NOTE
Examine the shipment to ensure the unit and manual are included and inspect the
unit for any visible damage.
Immediately notify the carrier and/or the supplier about an incomplete shipment
or any damage as a result of inadequate packaging or mishandling.
Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location
must ful l the following prerequisites:
•
Place the appliance on an easily accessible, level, dry, heat-resistant and su ciently
stable work surface to avoid spilling the hot liquid.
•
Ensure that there is su cient distance to strong heat sources such as hobs, heating
pipes, etc.
•
Choose the setup location in such a way that children cannot reach any hot surfaces
on the device.
•
The device is not intended to be installed in a wall or a built-in cupboard.
•
Do not set up the device in a hot, wet or extremely damp environment or near am-
mable material.
•
Do not use the device outdoors.
•
The device requires an adequate ow of air in order to operate correctly.
•
Ensure that the power cable does not hang down over a table or counter edge.
•
The electrical socket must be easily accessible so that the power lead can be discon-
nected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations (e.g.
on ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following inst-
ructions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequen-
cy) on the rating plate with those of your electrical network. This data must agree in
order that no damages occur in the device. If in doubt, ask your quali ed electrician.
•
The electrical outlet must be protected by a 16A safety cut-out switch, separately
from other electricity consumers,
•
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of re that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a quali ed electrician. The manufacturer cannot be made responsi-
ble for damages that are caused by a missing or damaged protective conductor.
14
CASO Raclette AirClean