Care And Maintenance; Changing The Blades - IKRA Mogatec EGN 2500 Gebrauchsanweisung

will automatically cut off the mains supply.
5
• Wait at least 1 minute before restarting by first press-
ing the reset button and then the on/off switch. If the
motor does not start, proceed as follows:
• Remove the plug from the outlet.
• Loosen the hand screws and open up the upper part.
• Carefully clean the cutting and ejection elements. Re-
move any objects that could prevent cutting.
• Put the upper part back in place and attach the hand
screws securely.
Press the reset button before pressing the on/off switch.
WARNING: Always wear protective gloves dur-
ing the above steps.
WARNING: Never loosen the hand screws be-
fore deactivating the unit and removing the plug
from the outlet.
7.3 Disassembly
Under certain circumstances (e.g. storage after use), the
machine can be disassembled by following the assembly
steps in reverse order.
7.4 Operating Instructions
• Place the material in the feed opening on the right
side. The machine automatically pulls it into the blade,
which rotates counter-clockwise.
• Do not place too much material into the opening at
once to avoid blocking the device. If shredding damp
GB | Operating Instructions
• Compost soft kitchen waste. Do not place it in the
• Branches with leaves must run through the machine
Reset
button
• Ensure that the shredded material does not block the
• Extended shredding of wood or shredding thick wood
• Soft material like leaves or small branches can clog
• Always check waste material for nails and stones
• Be careful in the event of vibrations; these are typically
• Always change the blade as necessary.

8. Care and maintenance

WARNING!
Before commencing cleaning and maintenance proce-
dures, make sure the garden shredder is switched off and
disconnected from the mains supply. Always wear sturdy
leather gloves when cleaning the cutter blades.
1. To ensure the best performance from the garden
2. Always clean the garden shredder immediately after
3. Do not allow material to become dry and hard on any
4. Make sure that the feeder chute and the ejection
5. Make sure that all nuts, bolts and screws are tight and
6. Always have any damaged, or worn parts repaired, or
7. Do not use any cleaning or solvent materials as these
8. Oil the blade after every fourth or fifth use.

8.1 Changing the Blades

6
The blades must always be changed in pairs. To do so,
GB-7
and rotted garden waste, alternate with branches so
as to avoid blocking the blade.
shredder.
completely before you can add more material. Please
ensure that the shredded material can fall into the col-
lection container freely without blocking the ejection
opening.
ventilation openings (cover, clog, etc.).
or strong branches can cause the machine to stop due
to clogging or jamming.
the machine easily. Use a stick or a rod to push this
material in.
since this could severely damage the shredder.
a sign of worn or damaged blades.
shredder, it must be kept clean.
use.
of the garden shredder surfaces. This will directly af-
fect the shredding performance.
chute are kept clean and clear of all waste material.
secure.
replaced by qualified personnel.
could cause irreparable damage to your machine.
Chemicals could destroy the artificial materials.