VEVOR BT-RTR42-ECG Originalanleitung Seite 12

Allows you to set a temperature trigger for the fans to run when your air
conditioner system on.Use this mode to set the temperature trigger for your
air conditioner. Please note you are NOT setting your desired temperature.
In this mode, the fans will run if the probe temperature meets or falls below
the trigger's cold temperature setting.It will not run if the probe temperature
is above the trigger's cold temperature setting.Press the up or down
buttons to set the cooling trigger temperature. To calibrate your register
booster fans, turn on your AC and wait for a few minutes until the probe
temperature stabilizes. Set your cooling trigger to this number or
higher.See the (fig.a.)
To avoid confusion, we recommend disabling the cooling trigger when not
using your AC. To disable it, hold the mode button for two seconds. The
display will show OF.We also recommend returning to the temperature
display mode once you finish adjusting your cooling trigger. See the
(Fig.b.)
5.Heating Trigger
Allows you to set a temperature trigger for the fans to run when your
central heating system is on.
Use this mode to set the temperature trigger for your heater. Please note
you are NOT setting your desired temperature.
- 11 -